Chinese | 
EnglishBending machine operation trilogyDate：2018-07-13 Clicks：327
The service life of the bending machine is closely related to the operator. The following is a brief introduction to the operation of the bending machine:1. Power on and start the oil pump.
First, turn on the power, open the key switch on the control panel, and then press the pump to start up, so you can hear the pump rotating (the machine is not moving at this time).
2. Adjust the stroke of bending machine
When using the bending machine, attention must be paid to adjusting the stroke. When the bottom of the mold on the bending machine is moved to the bottom, there must be a thickness clearance, otherwise it will damage the mold and machine. The stroke adjustment also has the electric quick adjustment and the manual fine tuning.
3. Select bend groove
Bend groove selection, the general choice of plate thickness 8 times the width of the slot. If bending 4mm plate material, about 32 slot should be selected.
Last but not least, the operator of bending machine needs to know that the rear baffle adjustment generally has electric quick adjustment and manual fine tuning, and the method is the same as the shearing machine. Step down the foot pedal switch to start bending, the bending machine is different from the cutting machine, can be loosened at any time, release the foot bending machine will stop, and continue to step down.
Related News
- Advantages of Dual Servo Oil-electric Hybrid CNC Press Brake2024-01-11
- Development trend of nc bending machine2018-07-13
- Application of nc bending machine industry brief2018-07-13
- CNC hydraulic bending machine only choose the right one not the expensive one2018-07-13
- How to improve the efficiency of hydraulic bending machine combined with stamping die2018-07-13
